![]() The annual cost of shrink wrap is lower than purchasing a permanent cover for your boat. Wet storing instead of dry this winter? Put the zipper door on the side facing the dock instead of the stern for different access from the dock. Planning teak work over the winter? Build the frame higher so you can stand. Depending on your needs and expectations you can use a different configuration every year when your boat is wrapped. Framed, supported and tied shrink wrap covers are very resistant to bad weather, rain and snow. Many canvas covers leave holes for stanchions or stop at the cap rails, all of which allows more moisture, Most shrink wrap installations cover the entire boat, wrapping the stanchions under the cover and overlapping the top of the hull. You shouldn't get puddles or snow buildup, both hazards of tarp and canvas covers. The slipperiness of the plastic also keeps the ice and snow from building up too quickly. Framing under shrink wrap can be set at a high angle to keep ice and snow from accumulating. ![]() Good installation prevents precipitation buildup.Canvas covers often have more breaks to go around stanchions and hardware which can be leak points. It shrinks tight, unlike tarps which can only be tied and secured in place. It's plastic, so it doesn't need any special treatment to be water resistant. Provides the best waterproof protection.Some pros of shrink wrapping for the winter include: So it's not a do-it-yourself project for many, though you can do it. There's an upfront cost for equipment, and framing and installation to survive the rigors of winter takes some skill. To get the most benefit of shrink wrap, it needs to be properly installed.
0 Comments
Leave a Reply. |